Identifier
etd-05272004-162258
Degree
Master of Science (MS)
Department
Electrical and Computer Engineering
Document Type
Thesis
Abstract
This work presents IDDQ testing of a CMOS first order sigma-delta modulator of an 8-bit oversampling analog-to-digital converter using a built-in current sensor [BICS]. Gate-drain, source-drain, gate-source and gate-substrate bridging faults are injected using fault injection transistors. All the four faults cause varying fault currents and are successfully detected by the BICS at a good operation speed. The BICS have a negligible impact on the performance of the modulator and an external pin is provided to completely cut-off the BICS from the modulator. The modulator was designed and fabricated in 1.5 μm n-well CMOS process. The decimator was designed on Altera's FLEXE20K board using Verilog. The modulator and decimator were assembled together to form a sigma-delta ADC.
Date
2004
Document Availability at the Time of Submission
Release the entire work immediately for access worldwide.
Recommended Citation
Chamakura, Anand K., "IDDQ testing of a CMOS first order sigma-delta modulator of an 8-bit oversampling ADC" (2004). LSU Master's Theses. 2428.
https://repository.lsu.edu/gradschool_theses/2428
Committee Chair
Ashok Srivastava
DOI
10.31390/gradschool_theses.2428