The influence of grafted cellulose nanofibers and postextrusion annealing treatment on selected properties of poly(lactic acid) filaments for 3D printing

Document Type

Article

Publication Date

6-1-2017

Abstract

l-lactide monomers were grafted onto cellulose nanofibers (CNFs) via ring-opening polymerization, forming poly(lactic acid) grafted cellulose nanofibers (PLA-g-CNFs). PLA-g-CNFs and pristine PLA were then blended in chloroform and dried to prepare a master batch. PLA-g-CNFs/PLA composite filaments targeted for 3D printing were produced by compounding the master batch in PLA matrix and melt extrusion. The as-extruded composite filaments were subsequently thermal annealed in a conventional oven, and their morphological, thermal, and mechanical properties were evaluated. PLA was successfully grafted on the surface of CNFs as demonstrated by elemental analysis, and the concentration of grafted PLA was estimated to be 33 wt %. The grafted PLA were highly crystallized, contributing to the growth of crystalline regions of PLA matrix. The incorporation of PLA-g-CNFs improved storage modulus of the composite filaments in both low temperature glassy state and high temperature rubbery state. Postextrusion annealing treatment led to 28 and 63% increases for tensile modulus and strength of the filaments, respectively. Simulated Young's moduli from the Halpin-Tsai and Krenchel models were found comparable with the experimental values. The formed composite filaments are suitable for use in 3D printing. © 2017 Wiley Periodicals, Inc. J. Polym. Sci., Part B: Polym. Phys. 2017, 55, 847–855.

Publication Source (Journal or Book title)

Journal of Polymer Science, Part B: Polymer Physics

First Page

847

Last Page

855

This document is currently not available here.

Share

COinS