The use of fractional-flow theory for foam displacement in presence of oil

Document Type

Article

Publication Date

1-1-2008

Abstract

Foam has been extensively used in improved and enhanced oil recovery processes in the petroleum industry over decades. Foam is capable of reducing gas mobility dramatically in porous media, and thus helps keep displacement fronts stable by controlling the mobility ratio between injected gas and reservoir fluids. In this study, models were constructed to investigate the mechanisms of foam displacement in porous media using three-phase fractional-flow theory and ternary diagrams. The strength of foam in the presence of oil was accounted for by using a mobility reduction factor (MRF) for the gas phase that can be routinely measured in laboratory coreflood experiments. The use of MRF is a typical way of describing foam rheology in local steady-state modeling. Results were analyzed in terms of saturation paths in the ternary diagr ams, saturation velocities, sweep efficiency and effluent history. Two different initial conditions were selected to demonstrate the importance of initial saturation on the displacement: one with oil phase dominant ((Sw, So) = (0.2, 0.8)) and the other with water phase dominant ((Sw, So) = (0.8, 0.2)). At low MRF (i.e., no foam or weak foam), the efficiency of foam displacement was primarily governed by fast-moving spreading waves that rapidly broke through the porous medium resulting in poor sweep efficiency. An increase in MRF (i.e., stronger foam) altered the nature of the displacement front by making it more piston-like through the development of "shock" fronts and improved sweep efficiency significantly. Once shock fronts dominated the displacement, the importance of initial saturation on the mechanisms of displacement became less pronounced. Calculations also demonstrated that a decrease in oil viscosity made the oil phase more mobile and the formation of shock fronts more prolific, significantly enhancing sweep efficiency. The results in this study imply that if basic fluid properties, injection and initial saturation conditions, and MRF are known, one can reliably predict the mechanisms of foam displacement in porous media even in the presence of oil. The solutions obtained from the three-phase fractional-flow analysis were in good agreement with simulation results in a wide range of MRF values and initial core conditions. Copyright © 2008 Society of Petroleum Engineers.

Publication Source (Journal or Book title)

SPE Reservoir Evaluation and Engineering

First Page

707

Last Page

718

This document is currently not available here.

Share

COinS